Difference Between 10K Demco eZ-Latch Couplers  

The Demco A-Frame Trailer Coupler part #DM14793-97 is designed for a standard a-frame trailer with a 50 degree angle. This is the most common type so there really shouldn't be any other issues that affect fit. That said, I have attached some…

There is! To replace the standard pin and clip on the Curt QuickPin No Latch A-Frame Trailer Coupler #C84DR Curt actually recommend the Hitch Lock #C23025 which is what I recommend going with!

You are correct. Other than how they are made, the Demco Cast Head Coupler w/ Jack Hole - eZ-Latch - 2" Ball - A-Frame - Bolt-On - 10K #DM37ZR and the #DM14793-81 have the same ratings and will work the same. There is no pro or con to either, so…

I have a solution for you. We do not carry hardware kits for the Demco Cast Head Coupler w/ Jack Hole - eZ-Latch - 2" Ball - A-Frame - Bolt-On - 10K #DM37ZR. However the instructions will give you the dimensions you will need and you can pick…

I checked the Featherlite Trailer website for specs on the model 3116 trailer but this part number returned no results. But if your trailer uses an industry-standard 50-degree a-frame design then the Demco A-Frame Trailer Coupler #DM16680-52 will fit…

The Demco Cast Head Coupler eZ Latch #DM37ZR coms as the coupler only so you would need to supply the mounting hardware. You will need 1/2" bolts that are at least Grade 5 rated. Anything higher than that will just be even stronger and work just…

To install the Demco A-Frame Trailer Coupler #DM16680-52 that you referenced, you will want to use 3/8 inch, grade 5 bolts , approximately 1-1/2 inches long (depending on how you are installing the coupler). You will want to use 5 of these bolts per…

If you look at the diagram that I received from my contact at Demco, you can see several of the dimensions of the #DM14793-81 trailer coupler. If there were other dimensions you were needing, please let me know.

Yes, the Demco A-Frame Trailer Coupler #DM14793-52 that you referenced could have holes drilled to match what you have on your trailer. This coupler would be a great option to replace a Ram brand coupler. I attached a picture that shows how the…

Thanks for that photo, I do appreciate it. And all of the couplers we have - and indeed all the ones I am aware of - require a frame that is fully engaged. While Demco was not able to provide a dimensional drawing, we did measure the Demco 50-Degree…

The back of the Demco A-Frame Trailer Coupler item #12660-97SP is 10-3/8" wide. I have linked a diagram below I made along with a review video.

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…