Filter Products
Filter by Doors
$347.24 - $347.24
Videos
for UTV Tops
Help Articles
for UTV Tops
Expert Answers
for UTV Tops
I hope I got the right measurement for you Roberto. I included a image with the measurement points that I took on the CargoBuckle Ladder Rack Straps #CB32MR below. If you are needing a different measurement please let me know.
view full answer...The Electric Jack w/ Footplate is offered both with the plug part #EJ-3527-BBX and without the plug part #EJ-3520-BBX. Therefore, if you wanted to go with the model that has the plug and just cut that off you would indeed just run the wire to the…
view full answer...I spoke with the manufacturer and they recommend using 160 ft-lb for the torque spec on a 3/4 inch U-bolt #11-70.
view full answer...According to the installation instructions from Dexter Axle the torque specs for the wet bolts on their Dexter E-Z Flex Suspension Kits, like part #K71-653-00, is 30 - 50 ft-lbs. I have attached a clip from their instructions for you to check out.
view full answer...Actually the type of roof vent cover you need to attach to the vent cover brackets of your Maxxair 4951KS like part #MA00-04500K is the part #MA00-955003 which uses those brackets with the included cotter pins of the cover.
view full answer...I went out to the warehouse to take a look at the Gustafson 12V RV LED Pendant Light w/ Light Shade #277-000456 and tried to disassemble it but they glued the screws in place on it so I wasn't able to take it apart without damaging the light.…
view full answer...With Curt Short Arm weight distribution systems like the part #C17322 that you referenced the distance from the center of the hitch ball to the far edge of the chain hanger will be 30-5/8 inches. A lot of times the best solution for V-nose trailers…
view full answer...The Dexter Nev-R-Adjust electric trailer brakes can be manually adjusted. There are a couple teeth of the adjustment wheel that are exposed just under the lever that you referenced. I have attached a photo showing the teeth. You will likely need a…
view full answer...I checked with Classic Accessories and the Classic Accessories All-Weather UTV Cab Enclosure part #CA18020 is listed as a fit for a Kawasaki Teryx 750 till 2015. Therefore, yes, it will fit a 2007.
view full answer...I do have an option for you but there isn't a weight distribution system specific to an American Hauler Enclosed Trailer. It looks like the old owner welded some brackets to the frame for a system but I'm not sure which one that was. The best…
view full answer...I do have an option for you but the Curt Bolt Kit for Trunnion Style Weight Distribution Hitch part #C17350 does not come with the spring bar retainer clips that you are referring to. Unfortunately, these retainers clips are not sold separately as…
view full answer...The parts in question are conical tooth washers. On the Curt weight distribution systems they go between the nuts and the head using the bolts that hold the head to the shank. I have included a picture that points them out for you. The tooth side…
view full answer...