Filter Products
Filter by Mounting Style
$26.77 - $58.29
Videos
for Dock Lights
Help Articles
for Dock Lights
Expert Answers
for Dock Lights
The 125255UC seal has a 1.249" ID and a 1.983" OD and for that our part #34823 will be the correct replacement.
view full answer...The Electric Jack w/ Footplate is offered both with the plug part #EJ-3527-BBX and without the plug part #EJ-3520-BBX. Therefore, if you wanted to go with the model that has the plug and just cut that off you would indeed just run the wire to the…
view full answer...Honestly, I would recommend you stick with the winch that came with the Neumann Boat Lift that you have. It was designed and tested for being used with your application and the only better alternative I would recommend would be to go with an…
view full answer...Yes, the Demco Spare Tire Carrier part #DM15851-76 does work great with the tire size ST235/80R16 that you referenced. We had a customer with your exact tire size send us a picture of it carrying the wheel which I attached.
view full answer...If you are not able to temporarily remove the antenna for storage another solution would be to create a protective barrier on your roof to keep your antenna from touching the cover. One makeshift example RV owners use is to create a pad to protect…
view full answer...The Jensen AWM965 and the new Jensen part #JWM60A have the same cut out size of 9" wide x 6" tall x 5-1/2" deep. The Jensen JWM60A is actually a replacement for the older Jensen AWM965 stereo so this will work well for you. The wiring…
view full answer...Since most of your trailer lights are functioning I would check the two subject lights' mounting and wiring for the cause for the problem. If the light uses a mounting stud or mounting hardware to establish the ground, like #MCL95AB, then you can…
view full answer...Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…
view full answer...Yes, the Reese Elite Series Underbed Rail Adapter for Standard 5th Wheel Trailer Hitches #RP30156 will work with your Reese Pro Series 5th Wheel Hitch! I have attached a quick installation video for you to check out as well.
view full answer...If your SuperGlide will work with industry standard fifth wheel rails that are 22 inches apart then the #RP30156 adapter will work for you. Some of the Pullrite hitches only fit their rails and adapters so if that is the hitch style you have then…
view full answer...Fifth wheel hitches can be pretty tall. Especially if you use a rail kit adapter like the #RP30156 which will add 2-3/4 inches from the floor of the truck bed to the top of the rail kit adapter. Most likely your Pullrite is going to sit too tall to…
view full answer...The Valley 7054 hitch is pretty old so info on it is harder to come by, but we do know that it is a slider hitch and that it fits the rails that the Reese adapter part #RP30156 provides. So if you have a 7054 hitch and a Ford truck with the factory…
view full answer...